Aluminum Die Casting Part Manufacturer

Aluminum Die Casting Part

Aluminum, copper, and zinc materials are usually applied in die casting part, the materials are easy to produce, we common the aluminum are 6063, 6064,6061, and 2021, the copper is H68 and H62, zine is ZAMAK 2、ZAMAK 3、ZAMAK5 and ZAMAK 7, these are material can be make into more complex shapes.

Factory strength

one-stop service, extrusion, CNC machining, and anodized

Customized service

research and development OEM/ODM service

Die casting part product display

What Is Die Casting

Die casting part is high precision, and the surface treatment is smooth and light, the die casting needs to open the mold, so can save the material,but needs mold charge. when opening the mold, we need attention to bubbles, pores, slag holes, pinholes, cracking, chipping, strain, deformation, misalignment, cold material, cold lines, cold insulation, undercasting, porosity, shrinkage cavities, mold flying, etc. All problems that cause problems and are frequent. The leading cause of quality problems is that the mold of die-casting products is not opened properly!
The die-casting mold design, performance, and service life constantly improve. In the die-casting industry, every process must be done carefully and accurately, and no one can be sloppy, because every process is important.

1: After the mold is finished, inspection is within the tolerance, and the dimensions and drawings t are all corresponding, die casting part is produced according to the drawing process.

2: In terms of size, the dimension of the die casting part, and the size of the mold meet the requirements of the 3D drawing file. For the position of mold, mold needs to adjust to appropriate, and the more important assembly positions should be measured by calipers inspection.

3: For some extremely irregular die casting part shapes,and positions with high size requirements, some positions that cannot be measured by common measuring tools, three-dimensional measurement is required if necessary.

4: The die casting part can not have rust, bumps, chipping, and burrs. At the same time, there should not be a large amount of residual material and oil stain.
5: produced according to 3D drawing, check whether the die casting part has been completely processed without omission, the benchmark is correct. All the positions requiring sharp corners (especially the sealing position) cannot be chamfered or R.And check the size according to the drawing and then check the self-check. stated on the slip.

6: The die casting requires no burrs on the surface and oil stain, wahs the die casting part by medicinal liquid, it protects the part’s life.
the die casting part.

The die casting part usually used in electronic , mechanical and automobile industries

customized from drawings

extrusion, CNC, and anodized

shipment on time